Alltel double layer outdoor camping …

The two short fiberglass tent pole to penetrate the middle of the crossbar after a cloth cover, loaded into two plastic fittings, top tents complete

First assembled steel (3 single link) They raised four corner tent to tent steel cast into the plastic connector, the other head head inserted in the four corners of the tent floor hoop nails, and then loaded on the middle part the four steel (steel rods used in long short corner section 4 in the intermediate portion)

Tent rainfly assembled as the following diagram: wind rope to tie up the nail, the correct way to tie a rope with a nail into the lawn should be at a 45 degree angle so that the nails and rope force was strong, lobby bar Similarly, foyer bar with nails wear tent cloth hall into the hole in the nail bolt rope to both sides of a good wind angle of 45 degrees from the ground to pull the wind lashing small. 3 holes on the plastic rope flap can be adjusted to the length of the rope used

Assembly Inner: Inner tent will pave Inner tent hook hook on the four corners of the tent’s rainfly hoop, on the other hook after hook Inner tent outside the account corresponding mount point, such as the location is not found on the check mark is not explained within your posting direction around backwards, you can change the direction of the front and rear doors!